HB2097 Threatens Oklahoma Vapor Products

HB2097 Threatens Oklahoma Vapor Products
Please Act Now!!!


Even though the House Public Health committee rejected
the language of SB 802, it was reintroduced as amendment
to HB 2097, and passed by the Senate less than 24 hours
later, giving Oklahoma electronic cigarette users very little
time to contact their legislators.

We support the ban on the sale of vapor products to minors,
but this bill does much more and would hurt an industry that
is helping thousands of Oklahomans quit smoking.

* Contrary to assertions by the amendments sponsor, the
bill, as amended, would increase taxes on Oklahoma ecigarette
users who don't use disposable models

* Required licensing would increase the cost of e-cigarette
products and lead to the unavailabity of hundreds or
thousands of products

* The bill would make it a criminal act for an e-cigarette user
to buy online without having a license, which would severely
limit access for Oklahomans living in rural areas

*The poor wording and unclear definitions would make
compliance extremely difficult

This bill is being heavily supported by RJ Reynolds and
Lorillard, two of the largest tobacco companies. By forcing
vapor product vendors to be licensed as tobacco retailers
and operate through tobacco channels this bill would give a
definite advantage to tobacco companies that carry
disposable e-cigarettes.

We urge lawmakers to look carefully at the implications of
this bill. We urge voters to contact their representatives and
ask them not to let the tobacco lobbyists convince them to
pass legislation that is bad for Oklahoma small business and
bad for Oklahoma public health.

BlackMesaVapors.com

www.CASAA.org

DCT Tank Filling Instructions

DCT Tank Assembly includes:
1 - Tube Assembly
1 - Dual Coil Cartomizer
1 - Plastic Drip Tip
___________________________________________________________________________

1. Obtain DCT tank assembly and a bottle of eliquid.
2. Remove the drip tip from the cartomizer.
3. Fill the cartomizer by dripping 15-20 drops of eliquid around the edges into the fabric filler. Be careful not to get eliquid into the center hole.
4. Slide the cartomizer partially out of the DCT tank.
5. Drip eliquid into the DCT tank around the cartomizer. As it fills, slide the cartomizer up to prevent liquid from going into the cartomizer. You can fill as close to the top as you would like without allowing the liquid to leak into the cartomizer.
6. Slide the cartomizer back into the top hole of the tank and align the bottom (threaded end) with the slot on the end of the DCT tank so it is fully inserted into bottom of the DCT tank.
7. Replace the drip tip. You will need to apply pressure to the bottom of the cartomizer while pushing the drip tip on to prevent the internal cartomizer from sliding out of the tube tank.
8. Screw onto your battery device and you are ready to use the DCT tank assembly.

Note: Although the pictures do not show it, I recommend leaving the battery attached to the cartomizer when filling the DCT cartomizer and tank.

Next, you should “prime” the tank. This is only used on the initial use of a new cartomizer.
1. Unscrew your battery from the DCT tank assembly.
2. Apply pressure to bottom of the cartomizer with your thumb to cut off all air flow.
3. Take two to three quick drags on the drip tip while still applying pressure with your thumb.
4. You should notice the eliquid in the DCT tank drop by about 1/4” to 3/8” which means it is now inside the cartomizer via the small laser hole in the cartomizer.
5. Now you should screw your battery onto the DCT tank assembly.
6. Hold down battery button for about 2 to 3 seconds while inhaling the vapor. Remember most eGo batteries have a 5-click on/off function. The button should light up when activated.
7. If you get a burnt taste, then repeat priming steps. If you get a smooth taste, then you can now enjoy your electronic cigarette!

BlackMesaVapors.com